Operating Manual Vol 1 - ES Documentation

SMIQMemory SequenceOperating Modes (MODE)The following operating modes are available:AUTOSINGLESTEPEXT-SINGLEEXT-STEPOFFRun from the beginning to the end of the list with automatic restart at thebeginning. If another mode was activated prior to the AUTO operating mode,continuation is made from the current index.IEC/IEEE-bus command: :SYST:MODE MSEQ;:SYST:MSEQ:MODE AUTO:TRIG:MSEQ:SOUR AUTOSingle run from the beginning to the end of the list. If SINGLE is selected, therun is not yet started. Below the MODE line, function EXECUTE SINGLESEQUENCE to be executed is displayed which can be used to start the run.IEC/IEEE-bus command :SYST:MODE MSEQ;:SYST:MSEQ:MODE AUTO:TRIG:MSEQ:SOUR SINGStep-by-step manual processing of the list. Activating STEP stops an automaticrun and the cursor wraps to the indication value of CURRENT INDEX. The listcan now be passed through upwards or downwards step by step using therotary knob.IEC/IEEE-bus command :SYST:MODE MSEQ;:SYST:MSEQ:MODE STEP:TRIG:MSEQ:SOUR SINGSingle run from the beginning to the end of the list as with SINGLE, buttriggered by an external trigger signal.IEC/IEEE-bus command :SYST:MODE MSEQ;:SYST:MSEQ:MODE AUTO:TRIG:MSEQ:SOUR EXTStep-by-step run using the external trigger signal. Each trigger event triggers asingle step.IEC/IEEE-bus command :SYST:MODE MSEQ;:SYST:MSEQ:MODE STEP:TRIG:MSEQ:SOUR EXTStep-by-step run using the external trigger signal. Each trigger event triggers asingle step.IEC/IEEE-bus command :SYST:MODE FIXExternal TriggerAn external signal at the rear input TRIGGER triggers the MEMORY SEQUENCE in the EXT-SINGLEand EXT-STEP operating modes. The polarity of the active trigger edge can be set in the UTILITIES -AUX I/O - EXT TRIG SLOPE menu.Menu MEM SEQ with the two menu pages OPERATION and EDIT offers access to thememory-sequence operating mode.1125.5555.03 2.407 E-9