Operating Manual Vol 1 - ES Documentation

Digital Standard GSM/EDGESMIQSelection: BURST TYPE = EDGEFig. 2-204Menu DIGITAL STD - GSM/EDGE - SELECT SLOT – EDGE, SMIQ equipped withModulation Coder SMIQB20 and Data Generator SMIQB11(SELECT SLOT...)EDGEBURST TYPESLOT LEVELSET DEFAULTHOP TRIGGERTAILOpens a window for selecting the burst type to be used forconfiguring the selected slot.EDGE EDGE Normal BurstIEC/IEEE bus :SOUR:GSM:SLOT2:TYPE EDGESelection of the level for the selected slot.OFF Maximum attenuationIEC/IEEE bus :SOUR:GSM:SLOT2:LEV OFFFULL The level is the same as that indicated in theLEVEL display of SMIQ.IEC/IEEE bus :SOUR:GSM:SLOT2:LEV FULLATTEN The level is reduced by the value set underSLOT ATTENUATION.IEC/IEEE bus :SOUR:GSM:SLOT2:LEV ATTResets the following parameters to the factory-selected values.IEC/IEEE bus command :SOUR:GSM:SLOT1:PRESSwitches the HOP trigger signal on or off. When set to ON, aHOP signal is generated at the end of the selected slot. Thesignal is available at the HOP output of the PARDATAconnector. It may be used for implementing frequencyhopping in the LIST MODE (see section "List Mode").IEC/IEEE-bus :SOUR:GSM:SLOT1:HOPP:TRIGDisplay of data contents in the 9-bit data field "Tail". The tailbits are permanently set to 111111111 in line with the GSMstandard.1125.5555.03 2.316 E-9