Operating Manual Vol 1 - ES Documentation

Basic Operating StepsSMIQ2.2.6 Use of [FREQ] and [LEVEL] KeysRF frequency and RF level can be set without menu operation as well using direct keys [FREQ] and[LEVEL]. The input value considers the offset, see Sections 2.4 and 2.5.Key [FREQ]/ [LEVEL] Press the [FREQ] or [LEVEL] key.The frequency and/or the level indication in the header field of the displayis marked.The current menu at the display is maintained. Alter the value via a value input or the rotary knob. Press the [RETURN] key.The menu cursor wraps to the position marked last in the menu.2.2.7 Use of [RF ON/OFF] and [MOD ON/OFF] KeysRF signal and modulation can be switched on/off without menu operation as well using direct keys[RF ON/OFF] and/or [MOD ON/OFF] (see Sections [RF ON/OFF] key and [MOD ON/OFF] key as well).Key [RF ON/OFF] Press the [RF ON/OFF] key.The RF output signal is switched on/off.IEC-bus-short command: :OUTP OFFKey [MOD ON/OFF] Press the [MOD ON/OFF] key.The modulation is switched on/off.An IEC-bus command is not available. The modulations have to be switchedon and off in the respective modulation sub menus2.2.8 [ENTER] Key – Special Toggle FunctionThis additional function of the [ENTER] key facilitates parameter changes.Some selection parameters can now be selected using the [ENTER] key, and no longer have to beactivated beforehand with [SELECT].2.2.9 Changing Unit of LevelFor the level, the unit of the value set can be changed without a new value input.Change level unit Activate LEVEL parameter.- Press the [LEVEL] key or- set the menu cursor in the LEVEL menu to the setting value of theAMPLITUDE parameter. Press the unit key with the desired level unit.The level is indicated in the desired unit.1125.5555.03 2.26E-8