Operating Manual Vol 1 - ES Documentation

Digital Standard IS-95 CDMASMIQTRIGGER MODE...Opens a window for selecting the CDMA sequence.AUTOThe calculated CDMA chip sequence is cyclicallyrepeated.IEC/IEEE-bus command :SOUR:IS95:SEQ AUTORETRIGThe CDMA chip sequence is continuously repeated. Atrigger event causes a restart from frame 1.IEC/IEEE-bus command :SOUR:IS95:SEQ RETRARMED_AUTO The CDMA chip sequence cannot be started from frame1 until a trigger event has occurred. The unit thenautomatically switches over to the AUTO mode and canno longer be triggered.IEC/IEEE-bus command :SOUR:IS95:SEQ AAUTARMED_RETRIG The CDMA chip sequence cannot be started from frame1 until a trigger event has occurred. each new triggerevent causes a restart.IEC/IEEE-bus command :SOUR:IS95:SEQ ARETEXECUTE TRIGGERExecutes a trigger event to start the CDMA chip sequence.IEC/IEEE-bus command :TRIG:DM:IMMTRIGGER...Opens a window for selecting the trigger source, for configuring the triggeroutput signals and for setting the time delay of an external trigger signal.FREQIS95100. 000 000 0 MHzLEVEL -30.0 dBmPEP - 13.9dBmFREQUENCYLEVELANALOG MODVECTOR MODDIGITAL MODDIGITAL STDLF OUTPUTSWEEPLISTMEM SEQUTILITIESPHSIS-95STATETRIGGER SOURCE INT EXTMODEEXT TRIGGER DELAY0 SymbSET DEFAULT EXT RETRIGGER INHIBIT0 SymbMODULATION...TRIGGER MODE TRIGGER OUT1EVEN SECONDEXECUTE TRIG TRIGGER OUT2 SHORT SEQ ROLLOVERTRIGGER.... TRIGGER OUT1 POL POS NEGCLOCK... TRIGGER OUT2 POL POS NEGTRIGGER OUT1 DELAY 0TOTAL POWER TRIGGER OUT2 DELAY 0ADJUST TO TOFig. 2-83Menu DIGITAL STD - IS-95 - TRIGGER..., equipped with options modulation coderSMIQB20, data generator SMIQB11 and SMIQB421125.5555.03 2.140E-9