Operating Manual Vol 1 - ES Documentation

Digital Standard 3GPP W-CDMA (FDD)SMIQPOWER CONTROLPREAMBLE LENGTHSIGNATUREACCESS SLOT#Length of Power Control Preamble in slots. Lengths between 0 and 8 slots canbe set.IEC/IEEE-bus command :SOUR:W3GP:MST2:PCPC:PLEN 8This field permits to determine the signature to be used for the PCPCH.Values between 0 and 15 can be set.IEC/IEEE-bus command :SOUR:W3GP:MST2: PCPC:SIGN 2Shifting of the starting time of the PCPCH. The value range is 0 to 14. (Shiftingof the starting time in time slots can be calculated as follows:2 * Access Slot #).IEC/IEEE-bus command :SOUR:W3GP:MST2: PCPC:ASLO 2FBI MODE OFF The FBI field is not used in the frame.IEC/IEEE-bus command:SOUR:W3GP:MST2:PCPC:FBI:MODE OFF1 BIT The FBI field is used in the frame and is 1 bit long.IEC/IEEE-bus command:SOUR:W3GP:MST2:PCPC:FBI:MODE D1B2 BIT The FBI field is used in the frame and is 2 bits long.IEC/IEEE-bus command:SOUR:W3GP:MST2:PCPC:FBI:MODE D2BFBI / FBI PATTERNSYMBOL RATEDATA / DATAPATTERNTFCISelecting the data source for the FBI field.ALL0 All 0s are continuously entered in the FBI field.IEC/IEEE-bus command:SOUR:W3GP:MST2:PCPC:FBI:DATA ZEROALL1 All 1s are continuously entered in the FBI field.IEC/IEEE-bus command:SOUR:W3GP:MST2:PCPC:FBI:DATA ONEPATT The FBI field is cyclically filled with a pattern that is up to 24 bitslong. A special pattern editor is displayed.IEC/IEEE-bus commands:SOUR:W3GP:MST2:PCPC:FBI:DATA PATT:SOUR:W3GP:MST2:PCPC:FBI:PATT #H3F, 8Symbol rate of the PCPCH. All symbol rates between 15 ksps and 960 kspsare available.IEC/IEEE-bus command :SOUR:W3GP:MST2:PCPC:SRAT D30KSelection of the data source for the DATA field. Selection from PN9, PN11,PN15, PN16, ALL0, ALL1 and PATTern. The PN generator function isexplained in section 2.12.3, for example. If PATTern data type is used, thepattern can be modified with a special editor. The length is limited to 24 digits.IEC/IEEE-bus command :SOUR:W3GP:MST2:PCPC:DATA PN9IEC/IEEE-bus command :SOUR:W3GP:MST2:PCPC:PATT #H1234, 15Value of the TFCI (Transport Format Combination Indicator) field in the controlpart of the PCPC. The value range of the TFCI is 0 to 1023.IEC/IEEE-bus command :SOUR:W3GP:MST2:PCPC:TFCI 1231125.5555.03 2.204E-9