11.07.2015 Views

Operating Manual Vol 1 - ES Documentation

Operating Manual Vol 1 - ES Documentation

Operating Manual Vol 1 - ES Documentation

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Fading SimulationSMIQSPEED UNITSET DEFAULTPATHSTATEPROFILEFREQ RATIOSPEEDDOPPLER FREQPATH LOSSDELAYIEC/IEEE-bus command :SOUR:FSIM:FDEL:STAN G3C1IEC/IEEE-bus command :SOUR:FSIM:FDEL:STAN G3UECn ( n=1...6)Notes:- The path delays correspond to those in 3GPP, TS 25.101 V4.1.0 (2001-06)und TS 25.141 V4.1.0 (2001-06). However, they include a basic delay of 25 nsof the Fading Simulator.- All test cases requiring more than 2 paths are only possible with optionSMIQB15.Selection of the unit required for the speed of parameter SPEED.IEC/IEEE-bus command :SOUR:FSIM:FDEL:SPE:UNIT KMPHSets the default setting of the path parameters with path 1 switched on and allother paths switched off.IEC/IEEE-bus command :SOUR:FSIM:FDEL:DEFIndicates the paths for subsequent parameters. These parameters can be setindividually for each path.Switch-on/off of a path. If the cursor is placed onto a path, this path may beswitched on or off by pressing one of the unit keys (toggle function).IEC/IEEE-bus command :SOUR:FSIM:FDEL:PATH2:STAT ON | OFFSelection of a fading profile. See explanations under Standard Fading. Onlythe following setting is possible:pDOPPIEC/IEEE-bus command :SOUR:FSIM:FDEL:PATH2:PROF PDOPRAYL (This setting is provided in the 3GPP test cases)IEC/IEEE-bus command :SOUR:FSIM:FDEL:PATH2:PROF RAYLEntry value of the ratio of the actual Doppler frequency shift to the set Dopplerfrequency with FDOP fading switched on. (See explanation under StandardFading).IEC/IEEE-bus command :SOUR:FSIM:FDEL:PATH2:FRAT 1Entry value of the speed v of the moving receiver (see explanation underStandard Fading).IEC/IEEE-bus command :SOUR:FSIM:FDEL:PATH2:SPE 100Entry value of the magnitude of the maximum Doppler frequency shift (seeexplanation under Standard Fading).IEC/IEEE-bus command :SOUR:FSIM:FDEL:PATH2:FDOP 92.3Entry value of attenuation in path.Value range: 0.0 to 50.0 dB.IEC/IEEE-bus command :SOUR:FSIM:FDEL:PATH2:LOSS 3Entry value of signal delay in path.Value range: 25 ns to 1637 µs.IEC/IEEE-bus command :SOUR:FSIM:FDEL:PATH2:DEL 14.5E-61125.5555.03 2.80 E-9

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!