Operating Manual Vol 1 - ES Documentation

SMIQExternal Modulation Source AMIQEXECUTE SINGLE Starts a single signal output. This menu item is displayed only with MODE =SINGLE.EXT TRIG SLOPESelects the polarity of an external trigger signal at connector TRIG. Thisexternal trigger signal generates a trigger event. This setting has an effect onmodes GATED (HIGH/LOW), EXT-AUTO and EXT-SINGLE (POS/NEG).FILTER Configuration of reconstruction filters for signal paths I and Q.OFFOutput of unfiltered I/Q signals2.5 MHz Loop in of the internal 2.5 MHz lowpass filter.25 MHz Loop in of the internal 25 MHz lowpass filterEXTLoop in of external bandpass filters for the I and Qchannel. For a detailed specification of the filter seeAMIQ manual, section Signal Inputs and Outputs.Note: With external filtering it has to be made sure that a filter isconnected to both filter inputs I and Q on the rear of AMIQ. Thetwo signal outputs can be switched off completely during externalfiltering provided that no filter is connected to the correspondingfilter input.LEVEL... Opens a window to set the level for the two signal paths I and Q.FREQ 100. 000 000 0 MHz LEVEL - 30.0 dBmFREQUENCYLEVELANALOG MODVECTOR MODDIGITAL MODDIGITAL STDAMIQ CTRLLF OUTPUTSWEEPLISTMEM SEQSETUP...SAVE/RECSELECT WMODEEXECUTEEXT TRIGFILTERLEVEL...MARKER..REFERENCOUTPUT TYPE UNBALANCED BALANCEDOUTPUT OFF IMPEDANCE 50 Ohm HIGHCHANNEL COUPLINGOFF ONLEVEL ILEVEL QOFF 0.5V/50 Ohm VAROFF 0.5V/50 Ohm VARFig. 2-231Menu AMIQ CTRL -LEVEL...1125.5555.03 2.363E-9