Operating Manual Vol 1 - ES Documentation

SMIQUtilities2.29.16 Setting Auxiliary Inputs/Outputs (AUX-I/O)Menu UTILITIES - AUX I/O offers access to settings for the TRIGGER input, BLANK output andMARKER output. Sections Sweep, LIST Mode and Memory Sequence provide further information.Menu selection:UTILITIES - AUX I/OFREQ100. 000 000 0 MHz LEVEL - 30.0 dBmFREQUENCYLEVELANALOG MODVECTOR MODDIGITAL MODDIGITAL STDLF OUTPUTSWEEPLISTMEM SEQUTILITIESSYSTEMREF OSCPHASEPROTECTCALIBDIAGTESTMOD KEYAUX I/OBEEPERINSTALLEXT TRIGGER SLOPE POS NEGSWEEP BLANK TIME NORM LONGBLANK POLARITY NORM INVMARKER POLARITY NORM INVFig. 2-273Menu UTILITIES - AUX I/OEXT TRIGGER SLOPESWEEP BLANK TIMEBLANK POLARITYMARKER POLARITYSelection of the active edge of the external trigger signal.POS The instrument triggers on the positive edge of theexternal signal.NEG The instrument triggers on the negative edge of theexternal signal.IEC/IEEE-bus command :TRIG:SLOP POSSelection of the blank duration.NORM BLANK duration is set to the shortest durationpossible.LONG The BLANK duration is set for the PEN LIFT control ofan XY recorder (approx. 500ms).IEC/IEEE-bus command :SOUR2:SWE:BTIM NORMSelection of the polarity for the blank signal.NORM With active BLANK, the output signal is HIGH.INV Polarity is inverted.IEC/IEEE-bus command :OUTP:BLAN NORMSelection of the polarity for the marker signal.NORM The output signal is HIGH when the sweep cyclereaches the mark.INV Polarity is inverted.IEC/IEEE-bus command SOUR:MARK:POL NORM1125.5555.03 2.429 E-9