Operating Manual Vol 1 - ES Documentation

SMIQSave/Recall2.2.12 Save/Recall - Storing/Calling of Instrument Settings50 complete instrument settings can be stored in memory locations 1 to 50.Operating stepsExplanationsSAVEDATA INPUT1 2x1ENTERStore current instrument setting inmemory location 12.RCLDATA INPUT1 2x1ENTERCall instrument setting of memorylocation 12.The digital display during a save or recall entry is faded in a window.Memory location 0 has a special function. Here the instrument setting which was current prior to the lastmemory recall and prior to a preset setting is automatically stored. This permits the resetting ofinstrument settings which have inadvertently been deleted using Recall 0.If an instrument setting is stored in which a sweep was switched on, the sweep is started using therecall.The parameter EXCLUDE FROM RCL in the FREQUENCY and LEVEL-LEVEL menus determineswhether the saved RF frequency and RF level are loaded when an instrument setting is loaded, orwhether the current settings are maintained.Store IEC-bus command: "*SAV 12"Recall IEC-bus command: "*RCL 12"Notes: - The contents of lists, as they are used for the Memory Sequence (MSEQ) or for usercorrection (UCOR), is not saved in the SAVE memory. It is stored under the respective listname and can be called. If instrument settings are called which go back to list data such aslevel setting using UCOR, the current list contents is used. If this has been altered, it is notidentical to the list contents at the point of storing any more.- The frame configurations (digital standards PHS, NADC, PDC, GSM, DECT) and the channelconfigurations (digital standards CDMA, W-CDMA, 3GPP W-CDMA) are not stored in theSAVE memory either. These settings can be stored and loaded via menu items SAVE/RCLFRAME and SAVE/RCL MAPPING in the corresponding DIGITAL STD menus.- The instruments comprise the "Fast Restore" mode for very fast loading of stored devicesettings. This mode can be called up only during remote control (see section 3, "Fast RestoreMode").1125.5555.03 2.43 E-8