Operating Manual Vol 1 - ES Documentation

Digital Standard GSM/EDGESMIQ(SELECT SLOT...)NORMBURST TYPESLOT LEVELSET DEFAULTHOP TRIGGERTAILDATASOpens a window for the selection of the burst type used toconfigure the selected slot.NORM Normal BurstIEC/IEEE :SOUR:GSM:SLOT2:TYPE NORMSelection of level for selected slot.OFF Maximum attenuationIEC/IEEE :SOUR:GSM:SLOT2:LEV OFFFULL The level corresponds to the value indicated onthe SMIQ LEVEL display.IEC/IEEE :SOUR:GSM:SLOT2:LEV FULLATTEN The level is reduced by the value set underSLOT ATTENUATION.IEC/IEEE :SOUR:GSM:SLOT2:LEV ATTResets the subsequent parameters to the factory-set values.IEC/IEEE-bus command :SOUR:GSM:SLOT8:PRESSwitches the HOP trigger signal on or off. With ON selected,a HOP signal will be generated at the end of the selectedslot. The signal is available at the HOP output of thePARDATA connector. It can be used to perform a frequencyhop mode in the LIST MODE (see section 'List Mode').IIEEE-bus command SOUR:GSM:SLOT1:HOPP:TRIGDisplay of data contents in the 3 bit data field "Tail". The tailbits are set to 000 according to the GSM standard.Selection of data source for DATA fields. These fields areregarded as a continuous field, i.e. a pseudo-randomsequence is fully continued from one DATA field to the next.The following data sources are available:PN.. PRBS data according to CCITT with periodsbetween 2 9 -1 and 2 23 -1.IEC/IEEE :SOUR:GSM:SLOT3:DATA PN15DLIST Data from a programmable data list.IEC/IEEE :SOUR:GSM:SLOT3:DATA DLISSERDATA Data from data input SER DATA.IEC/IEEE :SOUR:GSM:SLOT3:DATA SDATSetting for the so-called "Stealing Flag". The selected settingis valid for the two S fields.IEC/IEEE-bus command SOUR:GSM:SLOT2:SF 1TSC...Opens a window for selecting the so-called "TrainingSequence Code". A selection between 8 different trainingsequences is possible.IEC/IEEE-bus command SOUR:GSM:SLOT2:TSC 01125.5555.03 2.312 E-9