Operating Manual Vol 1 - ES Documentation

SMIQDigital Standard DECTPOWER RAMPCONTROL...Opens a window for setting the envelope control, especially for the rising andfalling ramp at the beginning and end of a slot.FREQDECT100. 000 000 0 MHzLEVEL -30.0 dBmPEP - 30.0 dBmFREQUENCYLEVELANALOG MODVECTOR MODDIGITAL MODDIGITAL STDLF OUTPUTSWEEPLISTMEM SEQUTILITIESPHSIS-95NADCPDCGSMDECTSTATEMODULATION...SET DEFAULTRAMP TIME 2.0 SymbTRIGGER MODE... RAMP FUNCTIOM LIN COSEXECUTE TRIGGER RAMP DELAY 0.0 SymbTRIGGER....RISE OFFSET 0 SymbCLOCK...FALL OFFSET 0 SymbPOWER RAMP CONTROL...SLOT ATTENUATION0 1 2FULLFig. 2-209Menu DIGITAL STD - DECT - POWER RAMP CONTROL... , SMIQ equipped withModulation Coder SMIQB20 and Data Generator SMIQB11(POWER RAMPCONTROL...)SET DEFAULTRAMP TIMERAMP FUNCTIONRAMP DELAYRISE OFFSETSets the subsequent parameters to factory-setdefault values.IEC/IEEE-bus SOUR:DECT:PRAM:PRESInput value for the rise and fall time of the envelopeat the beginning or end of a slot. The time is set inunits of the symbol period.IEC/IEEE-bus SOUR:DECT:PRAM:TIME 1.5Selection of shape of rising and falling ramp forenvelope control.LIN Linear ramp function.COS Cosine function. A more favorablespectrum than that of the LIN function isobtained.IEC/IEEE-bus SOUR:DECT:PRAM:SHAP LINInput value for a shift of the envelope characteristicto the modulated signal. A positive value causes adelay of the envelope. The values are set in units ofthe symbol length.IEC/IEEE-bus SOUR:DECT:PRAM:DEL 0.1Input value for a positive or negative offset of therising ramp of the envelope at the beginning of a slot.IEC/IEEE-bus SOUR:DECT:PRAM:ROFF -1FALL OFFSETInput value for a positive or negative offset of thefalling ramp of the envelope at the end of a slot.IEC/IEEE-bus :SOUR:DECT:PRAM:FOFF 11125.5555.03 2.327 E-9