Operating Manual Vol 1 - ES Documentation

SMIQDigital Standard DECT(SELECT SLOT) SLOT LEVEL Selection of the level for the selected slot.OFF Maximum attenuationIEEE bus :SOUR:DECT:SLOT2:LEV OFFFULL The level corresponds to the value indicated onthe SMIQ LEVEL display.IEEE bus :SOUR:DECT:SLOT2:LEV FULLATTEN The level is attenuated by the value set underSLOT ATTENUATION.IEEE bus :SOUR:DECT:SLOT2:LEV ATTNote:If the cursor is placed onto a slot in the diagram,the SLOT LEVEL may be modified by pressingone of the unit keys (toggle function).SET DEFAULTSLOT TIMINGSHIFTCW DURINGRAMP UPRAMPNORMALPREAMBLEResets the subsequent parameters to factory-set defaultvalues.IEC/IEEE-bus command SOUR:DECT:SLOT8:PRESInput value for the number of bits used for simulating a faultyslot timing. The active slot is shifted in time by the selectednumber of bits. A positive input value delays the slot, anegative value advances the slot in time.IEEE bus command :SOUR:DECT:SLOT2:STSH 1Switches the modulation during the rise of the power rampon or off.ON Before the preamble starts, the modulation isswitched off so that only the unmodulatedcarrier is generated.OFF Before the preamble starts, the modulation isswitched on and the data bits in the ramp fieldare modulated.IEEE bus command :SOUR:DECT:SLOT2:RAMP:CW ONInput value for the 12-bit data field RAMP in binary format.This data field is not defined in the DECT standard. It is usedto define the data contents during the rise of the power ramp.A series of data representing the natural extension of thepreamble bits in forward direction is set by default.IEEE :SOUR:DECT:SLOT2:RAMP:DATA #B111111111111Input value for the NORMAL PREAMBLE in binary format.According to the DECT standard, the default setting for this16-bit data field is different for uplink and downlink slots. Thisdata field is not available for slot type ALL_DATA.IEEE :SOUR:DECT:SLOT2:PRE:DATA #B1010...1125.5555.03 2.331 E-9