Operating Manual Vol 1 - ES Documentation

Enhanced Functions For Digital Standard 3GPP W-CDMA (FDD)SMIQOCNS CHANNELSTOTAL POWERP-CCPCH STATEP-CCPCH POWERENHANCED CH.TOTAL POWEREXECUTE ►Fraction of power of OCNS channel signal component at the overall signalnormalized to 0 dB. This menu parameter is only effective after pressingEXECUTE ►.IEC/IEEE-bus command :SOUR:W3GP:BST:OCNS:POW –10.0Switch with which the P-CCPCH can be added to the OCNS dedicatedchannels. This menu parameter is only effective after pressing EXECUTE ►.IEC/IEEE-bus command :SOUR:W3GP:BST:OCNS:PCCP:STAT ONFraction of power of P-CCPCH signal component at the overall signalnormalized to 0 dB. This menu parameter is only effective after pressingEXECUTE ►.IEC/IEEE-bus command :SOUR:W3GP:BST:OCNS:PCCP:POW –10.0Fraction of power of enhanced channel signal component at the overall signalnormalized to 0 dB. The value for ENHANCED CH. TOTAL POWER isdetermined from the POWER START values of all activated enhancedchannels and offered to the user as default value. If the user changes thisvalue, also the values for POWER START of the activated enhancedchannels are adapted. If all enhanced channels are inactive, ENHANCED CH.TOTAL POWER are set to –60.0 dB.This menu parameter is only effective after pressing EXECUTE ".IEC/IEEE-bus command :SOUR:W3GP:BST:OCNS:EPOW –10.0The EXECUTE command is used to validate the settings described above andto fill in the channel tables of the base stations.The rules for filling in the channel tables correspond to those of thePARA.PREDEF SETTING... menu parameter with the following exceptions:The first 4 DPCHs are reserved for the enhanced channels. The OCNSchannel settings are entered from the 5th DPCH in the channel table. Themaximum number of DPCHs (= OCNS channels) is reduced by 4 (= numberof enhanced channels).S-CCPCH is switched off (STATE = OFF).The channel power values of OCNS channels must be determined from menuparameters NUMBER OF OCNS CHANNELS and OCNS CHANNELS TOTALPOWER. The P-CCPCH channel power is taken over from P-CCPCH POWERmenu parameter (if P-CCPCH is switched on) .IEC/IEEE-bus command :SOUR:W3GP:BST:OCNS:EXEC1125.5555.03 2.258 E-9