particular specifications (road works) - CIDCO Maharashtra Ltd.

More documents

Recommendations

Info

CIDCO OF MAHARASHTRA LTD C.A.No.01/CIDCO/SE(KHR)/EE(KHR-I)/2010–11 Pg. No. 542 1.2.4 Curing: v) To secure even and dense surfaces free from aggregate pockets, vibration shall be supplemented by tamping or rodding by hand in the corners of forms and along the form surfaces while the concrete is plastic. vi) A sufficient number of spare vibrators shall be kept readily accessible to the place of deposition of concrete to assure adequate vibration in case of breakdown of those in use. 25mm diameter immersion vibrators shall be used in thin sections upto 125mm, 40mm diameter immersion vibrators in fairly wide sections like beams, slabs, columns etc. and 60mm diameter vibrators in foundation, pilecaps or such large section members. Screed vibratos shall also be used for slab concreting. vii) Plain concrete also shall be vibrated whenever and wherever directed by EIC to achiever full compaction, using needle and screed vibrators as necessary. Curing shall be started at the earliest by spreading wet jute cloth (hessian) and cover top with impervious sheet and subsequently cured with spraying water. In inaccessible area to start with, curing be started by spraying curing compound before starting membrane curing. 1.3 Placing temperatures : During extreme hot weather, the concreting shall be done as per procedures set out in IS: 7861, Parts I & II.
CIDCO OF MAHARASHTRA LTD C.A.No.01/CIDCO/SE(KHR)/EE(KHR-I)/2010–11 Pg. No. 543 Fine and coarse aggregates concreting shall be kept shaded and the concrete aggregates sprinkled with water for a sufficient time before concreting, in order to ensure that the temperature of these ingredients is as low as possible prior to batching. The mixer and batching equipment shall be also shaded and if necessary painted white in order to keep their temperatures as low as possible. The placing temperature of concrete shall be as low as possible in warm weather and care shall be taken to protect freshly placed concrete form over heading by sunlight in the first few hours of its laying. The time of day selected for concreting shall also be chosen so as to minimize placing temperatures. In case of concreting in exceptionally hot weather the Engineer may in his discretion specify the use of ice either flaked and used directly in the mix, or blocks, used for chilling the mixing water. In either case no extra payment shall be made to the contractor on this account. 1.4 Construction joints : Construction joints in all concrete work shall be made as directed by the Engineer. Where vertical joints are required, these shall be shuttered as directed and not allowed to take the natural slope of the concrete. Before fresh concrete is placed against a vertical joint, the old concreter shall be chipped/sand blasted, cleaned and moistened 25 hours before placing the concrete. All standing water should be removed and dried with compressed air. Neat cement slurry shall be applied on the chipped/sand blasted surface and mortar of the same water cement ratio as the concrete and 10mm thick applied.
Page 1 and 2:
CIDCO OF MAHARASHTRA LTD C.A.No.01/
Page 3 and 4:
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244: CIDCO OF MAHARASHTRA LTD C.A.No.01/
Page 293: CIDCO OF MAHARASHTRA LTD C.A.No.01/
Page 319: CIDCO OF MAHARASHTRA LTD C.A.No.01/
show all

particular specifications (road works) - CIDCO Maharashtra Ltd.

Create successful ePaper yourself

Delete template?

Save as template?