NX Nastran DMAP Programmer's Guide - Kxcad.net

1020
EMG
Computes elemental matrices
1Otherwise
COUPMASS Input-integer-default=-1. Coupled mass generation flag.
-1 Lumped
0Coupled
TEMPSID Input-integer-default=-1. Temperature set identification number.
Usually obtained from the TEMPERATURE Case Control command.
Required for use in stress recovery of differential stiffness.
DEFRMID Input-integer-default=-1. Element deformation set identification
number. Usually obtained from the DEFORM Case Control
command. Required for use in stress recovery of differential
stiffness.
PENFAC Input-real-default=0.0. Penalty factor for electromagnetic elements.
NOPNLT Input-integer-default=-1. Penalty function flag for electromagnetic
elements.
LUMPB Input-real-default=0.0. Lumping factor for electromagnetic
damping.
LUMPM Input-real-default=0.0. Lumping factor for electromagnetic mass.
MATCPX Input-integer-default=-1. Complex material properties flag for
electromagnetic elements.
KDGEN Input-integer-default=0. Differential or follower stiffness matrix
generation flag. Usually the column number in UG to use in
differential stiffness matrix generation. If KDGEN is negative then
follower stiffness will be generated.
TABS Input-real-default=0.0. Absolute temperature conversion. For
example, set to 273.16 when specifying temperatures in Celsius or
459.69 in Fahrenheit.
SIGMA Input-real-default=0.0. The Stefan-Boltzmann constant. Used to
compute radiant heat flux.
K6ROT Input-real-default=0.0. Normal rotational stiffness factor for
CQUAD4 and CTRIA3 elements.
LANGLE Input-integer-default=1. Large rotation calculation method:
1 Fimbal angle
2Rotation vector
NOBKGG Input-integer-default=0. Slideline contact stiffness generation flag.
Set to 1 to generate slideline contact stiffness.