NX Nastran DMAP Programmer's Guide - Kxcad.net

722
Name Type and Description
NX Integer. Number of extra aerodynamic degrees-of-freedom. Output
by ADG.
OADPMAX Integer. Total number of adaptivity cycles performed.
OBJIN Real. Initial objective value.
OBJOUT Real. Final objective value. Output by DOM9.
OBJSID Integer. Superelement identification number associated with
DESOBJ. Set to -1 for all cases unless the user specifies the DESOBJ
command in a particular superelement subcase. Output by
MDCASE.
OBJVAL Real. Objective value. Output by DSAD.
ODESMAX Integer. Total number of design cycles performed.
OG Integer. CURV module's grid point processing flag. If set to 0, then
grid point stresses or strains are computed.
OLDDT Real. Time step increment used in the previous iteration or time step
to be used after the matrix update or subcase switch. Output by
NLTRD and NLTRD2.
OLDNAMi Character. The generic name of the corresponding output; e.g.,
OLDNAM3 corresponds to OLDDB3, etc.
OMEGAJ Real. Imaginary part of shift point Aj for pre-Version 70.5 Lanczos
method.
OMID Character. Material output coordinate system flag. If OMID='YES'
then stresses, strains, and forces are output in the material coordinate
system of CQUAD4, CTRIA3, CQUAD8, and CTRIA6 elements.
OPERATN Character. FORTIO operation.
'EXISTS' Check for assigned physical file existence
'OPEN' Open file
'CLOSE' Close file
OPT Character. DIAGONAL module processing option.
'COLUMN' Extract diagonal to a column matrix and raise all
elements to POWER
'SQUARE' Extract diagonal to a square matrix and raise all
elements to POWER