NX Nastran DMAP Programmer's Guide - Kxcad.net

1423
SSG3
Computes static solutions
SSG3 Computes static solutions
Computes the static solutions.
Format:
SSG3 LLL,UNUSED2,KLL,PL,LOO,UNUSED6,KOO,PO,LSEQ/
UL,UO,RUL,RUO,EPSSE/
NOOSET/UNUSED2/NSKIP/S,N,EPSI/S,N,EXTWORK/SEID $
Input Data Blocks:
LLL Lower triangular factor/diagonal for the l-set from KLL.
UNUSED2 Unused and may be purged.
KLL Stiffness matrix reduced to the l-set.
PL Static load matrix reduced to the l-set.
LOO Lower triangular factor/diagonal for the o-set from KOO.
UNUSED6 Unused and may be purged.
KOO Stiffness matrix partitioned to the o-set from KFF.
PO Static load matrix partitioned to the o-set.
LSEQ Resequencing matrix based on internal resequencing of KLL in DCMP.
Output Data Blocks:
UL Displacement matrix in l-set.
UO Displacement matrix in o-set.
RUL Residual matrix for the l-set
RUO Residual matrix for the o-set
EPSSE Table of epsilon and external work.
Parameters:
NOOSET Input-integer-no default. Number of degrees-of-freedom in the o-set
or omitted degree-of-freedom flag. Set to -1 if there are none.
UNUSED2 Input-integer-no default. Not used but specify 0.
NSKIP Input-integer-default=1. The record number in CASECC
corresponding to the first subcase of the current boundary condition.
EPSI Output-integer-default=1. Static solution error ratio flag. Set to -1 if the
error ratio is greater than 1.E-3.