NX Nastran DMAP Programmer's Guide - Kxcad.net

Name Type and Description
DFRQCC Logical. Direct frequency response analysis subcase flag. Set to TRUE
if at least one ANALYSIS=DFREQ command was found in CASECC
and CASEFREQ is specified in the output list. Output by MDCASE.
DIGITS Integer. Number of digits for the fractional part of values written by
the OUTPUT4 module.
DISMETH Integer. Method of processing in DISUTIL module.
DISVAR Logical. Discrete optimization variable flag. Set to TRUE if discrete
optimization design variables are specified. Output by DOPR1.
DMRESD Integer. Design model flag. If set to -1, then the design model is
limited to the residual structure. Output by SDSB.
DOANALY Integer. Any analysis retained response flag. Set to >0 if any retained
response. Output by DSPRM.
DOBUCK Integer. Buckling constraint flag. Set to >0 if any constraint. Output
by DSPRM.
DOCEIG Integer. Complex eigenvalue response retained response flag. Set to
>0 if any retained response.
DODIVG Integer. Divergence analysis retained response flag. Set to >0 if any
retained response. Output by DSPRM.
DOESE Integer. Static analysis retained element strain energy response flag.
Set to >0 if any retained response. Output by DSPRM.
DOFLUT Integer. Flutter analysis retained response flag. Set to >0 if any
retained response. Output by DSPRM.
DOFREQ Integer. Frequency response retained response flag. Set to >0 if any
retained response. Output by DSPRM.
DOFSPC Integer. Frequency response retained SPCforce response flag. Set to
>0 if any retained response. Output by DSPRM.
DOMODES Integer. Normal modes constraint flag. Set to >0 if any constraint.
Output by DSPRM.
DOMTRAN Integer. Transient response retained response flag. Set to >0 if any
retained response. Output by DSPRM.
DOPT Integer. Scaling method between grid points on the abscissa for the
CURVPLOT module.
691