NX Nastran DMAP Programmer's Guide - Kxcad.net

Name Type and Description
-1 Lumped
0 Coupled
CP Integer. DBC module control parameter. Output by DBC.
CSTRN Integer. Composite lamina strain constraint flag. Set to >0 if any
constraint. Output by DSPRM.
CSTRES Integer. Composite lamina stress constraint flag. Set to >0 if any
constraint. Output by DSPRM.
CTYPE Character. Cyclic symmetry type as specified on CYSYM Bulk Data
entry. Output by CYCLIC1.
'ROT' Rotational
'AXI' Axisymmetric
'DIH' Dihedral
CVTYP Integer. Type of convergence test.
1 Soft convergence is to be checked
2 Hard convergence is to be checked
3 Final iteration histories are to be printed
CYCLIC Logical or integer. Set to TRUE or -1 for cyclic symmetry models.
DATAREC Integer. Data recovery flag. If DATAREC>0, then DPD will not
perform UFM 2071 checks for DELAY and DPHASE which are not
need in data recovery.
DBCPATH Integer. Dummy variable parameter to allow passing of qualifiers
from the NASTRAN database to the DBC database.
DCEIGCC Logical. Direct complex eigenvalue analysis subcase flag. Set to
TRUE if at least one ANALYSIS=DCEIG command was found in
CASECC and CASECEIG is specified in the output list. Output by
MDCASE.
DEBUG Integer. Passive column logic control flag in DCMP and DECOMP.
DECOMP Integer. DCMP and DECOMP module error termination flag.
DEFORMED Integer. Deformed plot request flag.
1 Plot undeformed shapes
-1 Plot deformed shapes
689