NX Nastran DMAP Programmer's Guide - Kxcad.net

648
Chapter 3
Name
Chapter 2
Name
Description
P2G Matrix defined on DMIG Bulk Data entries and
referenced by the P2G Case Control command. Output
by MTRXIN.
PA Static load matrix reduced to the a-set. Output by SSG2.
PA* Family of static load matrices (PA) applied on the
boundary (a-set) of all upstream superelements.
PAK Aerodynamic forces at aerodynamic boxes.
PANSLT Panel static load table. Output by GP5.
PARTVEC Partitioning vector with values of 1.0 at the rows
corresponding to degrees-of-freedom which were
eliminated in the partition to obtain KXX, etc. Required
for maximum efficiency during symmetric
decomposition and if KXX represents a subset of the
d-set (SETNAME='D'). PARTVEC is not required if KXX
represents the h-set. See SETNAME parameter
description below.
PBGPDT BGPDT Basic grid point definition table updated to support
plotting CHBDYi elements. Output by PLTHBDY.
PBYG Matrix of equivalent static loads due to enforced velocity
for the g-set.
PC Optional stepwise preconditioner in SOLVIT and
STATICS, same as A and KGG respectively.
PC1 Updated stepwise preconditioner matrix. Output by
SOLVIT and STATICS.
PCDB Table of model (undeformed and deformed) plotting
commands. Output by IFP1.
PCDBS Table of model (undeformed and deformed) plotting
commands for the current superelement (identification
number equal to output value of SEID). Output by
SEP2CT.
PCDBDR Table of model (undeformed and deformed) plotting
commands for the superelement (identification number
equal to output value of SEID). Output by SEDR.