NX Nastran DMAP Programmer's Guide - Kxcad.net

If OPT2 = 4, OPT1 chooses CSUPER entry as follows:
TABPRT
Formatted table printer
OPT1
Value
Meaning
>0 Write CSUPER Bulk Data entries for superelement OPT1.
≤ 0 Write CSUPER Bulk Data entries for residual structure
but give SEID = - OPT1.
OPT2 Integer-default = 0. Print/punch selection as follows:
OPT2
Value
Meaning of Selection
-1 No output (1, 2 and a record for each superelement).
0 Print contents of all records (1, 2 and a record for each
superelement) of SEMAP except last two.
1 Print only Record 1 contents.
2 Print contents of Records 1 (except for OPT1 < 0) and 2
(see OPT1 for selection options within Record 2).
3 Print contents of Records 1, 2 and a record for each
superelement giving a list of internal points, a list of
external points, a list of elements, and estimation data
for the superelement. The third part of each
superelement record (containing the lists of primary
superelement points to which a secondary
superelement is connected) is omitted.
4 Punch CSUPER entries according to OPT1 (see
Remarks).
5 Print only Records 1 (except for OPT1 < 0), 2 (see OPT1
for selection options within Record 2), and estimation
data for each superelement.
144