NX Nastran DMAP Programmer's Guide - Kxcad.net

SDRP
Computes data for p-elements
SDRPOPT Input-character-no default. Principal stress/strain computation
selection:
Remarks:
'SDRP' Compute in SDRP
'OFP' Compute in OFP
PVALID Input-integer-no default. p-value set identification number.
DESCYCLE Input-integer-no default. Design cycle analysis counter.
ADPTINDX Input-integer-no default. p-version analysis adaptivity index.
ODESMAX Input-integer-no default. Total number of design cycles performed.
OADPMAX Input-integer-no default. Total number of adaptivity cycles
performed.
SEID Input-integer-no default. Superelement identification number.
1. If disk space is critical then SDRPOPT may set to 'OFP' to delay computation of
principal stresses and strains to the OFP module.
2. The scope of SDRP processing depends on the value system cell 297:
0 Traditional NASTRAN data recovery
1,2,3 On-the-fly data recovery
-1 Global Response (i.e. find min/max values of certain data recovery
quantities)
136