NX Nastran DMAP Programmer's Guide - Kxcad.net

1369
SECONVRT
Modifies Bulk Data entry records
SECONVRT Modifies Bulk Data entry records
Modifies those Bulk Data entry records which define coordinate systems, orientation
vectors, and load vectors by grid point identification number; e.g., CORD1j to
CORD2j, FORCEi to FORCE, MOMENTi to MOMENT, replace GO on CBAR,
CBEAM, CBEND, CBUSH and CGAP with X1, X2, X3.
Format:
SECONVRT BGPDT,GEOM1,GEOM2,GEOM3/
GEOM1N,GEOM2N,GEOM3N $
Input Data Blocks:
BGPDT Basic grid point definition table.
GEOM1 Table of Bulk Data entry images related to geometry.
GEOM2 Table of Bulk Data entry images related to element connectivity
and scalar points.
GEOM3 Table of Bulk Data entry images related to static and thermal
loads.
Output Data Blocks:
GEOM1N Modified GEOM1 with CORD1j records converted to CORD2j
records
GEOM2N Modified GEOM2 with GO replaced by X1, X2, and X3 on CBAR,
CBEAM, CBEND, CBUSH and CGAP records.
GEOM3N Modified GEOM3 with FORCEi and MOMENTi records converted
to FORCE and MOMENT records.
Parameters:
None.
Remark:
1. System cell 350 controls execution of the SECONVRT module.
-1 no converson
0 convert and echo all converted entries in the f06
>0 convert and echo the first n converted entries in the f06 where n is the
value of system cell 350