NX Nastran DMAP Programmer's Guide - Kxcad.net

Remarks:
1. VGA may be purged if no diagnostic printouts are desired.
2. If STRUCTMP>0 then these are the output options:
• Compute structural mode participation factors.
MODEPF
OFREQ and OTIME command processor
FLUIDMP Input-integer-default=-1. Number of fluid modes to use in
computing factors. If FLUIDMP>0 then compute factors for the first
FLUIDMP modes.
STRUCTMP Input-integer-default=-1. Number of structure modes to use
computing factors.
PANELMP Input-integer-default=-1. Flag to compute panel participation factors.
See Remark 2.
GRIDMP Input-integer-default=-1. Case Control set identification number for a
set of fluid grids.
NOSASET Input-integer-default=-1. Number of degrees-of-freedom in the a-set
of the structure.
FILTERF Input-real-default=0.95. Filter for fluid factor matrices.
FILTERS Input-real-default=0.95. Filter for structure factor matrices.
• If MPNFLG>0 and PANELMP>-1 then compute panel mode participation
factors, PMPF.
• Compute load mode participation factors, LMPF.
• If MPNFLG>0 and GRIDMP>-1 then compute fluid grid mode participation
factors, GMPF.
120