NX Nastran DMAP Programmer's Guide - Kxcad.net

IFP1 Reads Case Control Section
Reads the Case Control Section.
Format:
Output Data Blocks:
Parameter:
IFP1
Reads Case Control Section
IFP1 /CASECC,PCDB,XYCDB,POSTCDB,FORCE/S,N,NOGOIFP1/
S,N,LASTCC/S,N,BEGSUP $
CASECC Table of Case Control command images.
PCDB Table of model (undeformed and deformed) plotting commands.
XYCDB Table of x-y plotting commands.
POSTCDB Table of commands from the OUTPUT(POST) section of Case Control.
FORCE Table of MSGSTRESS plotting commands defined under the
OUTPUT(CARDS) section in CASE CONTROL and MSGMESH field
information.
NOGOIFP1 Logical-output-default=FALSE. Set to TRUE if an error is detected in
the Case Control Section.
LASTCC Integer-output-default=0. Set to 2 if the last auxiliary model Case
Control section is being processed.
BEGSUP Logical-output-default=FALSE. BEGIN SUPER flag. Set to TRUE if the
first Bulk Data section begins with BEGIN SUPER instead of BEGIN
BULK.
Remarks:
1. IFP1 does not stop if an error is detected in the Case Control section; therefore, the
following statement should appear after the module:
IF (NOGOIFP1) EXIT $
2. IFP1 may be executed only once and should appear at the beginning of the DMAP
sequence before any other module.
108