NX Nastran DMAP Programmer's Guide - Kxcad.net

SEP2DR
Drives superelement generation, assembly, and reduction loop
LASTSE Output-integer-default=0. Last superelement flag. Set to -1 if the
current superelement is the last to process.
NOMAT Output-integer-default=0. Matrix generation flag. Set to -1 if no matrix
generation is requested for the current superelement based on the
SEMG or SEALL Case Control commands.
NOASM Output-integer-default=0. Matrix assembly flag. Set to -1 if no matrix
assembly and reduction is requested for the current superelement
based on the SEKR or SEALL Case Control commands.
NOLOAD Output-integer-default=0. Load generation flag. Set to -1 if no load
generation is requested for the current superelement based on the
SELG or SEALL Case Control commands.
NOLASM Output-integer-default=0. Load assembly flag. Set to -1 if no load
assembly and reduction is requested for the current superelement
based on the SELR or SEALL Case Control commands.
NOUP Output-integer-default=0. Upstream superelement flag. Set to -1 if
there are no superelements connected upstream from the current
superelement.
SCNDRY Output-integer-default=0. Secondary (identical or mirror)
superelement flag. Set to -1 if superelement is defined by the CSUPER
Bulk Data entry with PEID>0.
EXTRN Output-integer-default=0. External superelement flag. Set to -1 if
superelement is defined by the CSUPER Bulk Data entry with PEID=0.
NOMR Output-integer-default=0. Mass and damping assembly flag. Set to -1 if
no mass and damping assembly and reduction is requested for the
current superelement based on the SEMR or SEALL Case Control
commands.
SEP2CNTL Input-character-default='SLIST'. Processing list selection.
'ALL' All superelements will be processed.
'PSLGDV' Only superelements specified on the SEDV Case Control
commands.
'DSLIST' Only superelements specified on the SERESP Case Control
commands.
'SLIST' Only superelements specified on the SEALL, SEMG,
SEKR, SELG, SELR, or SEMR Case Control commands.
138