NX Nastran DMAP Programmer's Guide - Kxcad.net

BCDR Drives a boundary condition loop
BCDR
Drives a boundary condition loop
Drives a DMAP loop based on the boundary condition Case Control commands SPC
and MPC.
Format:
BCDR CASECC//
SEID/SOLAPP/S,N,NSKIP/S,N,NLOADS/S,N,BCFLAG/S,N,SPC/
S,N,MPC/S,N,SUPORT/S,N,LOAD/S,N,LSEQ/S,N,STATSUB/
S,N,BC/
BCLABL $
Input Data Block:
CASECC Table of Case Control command images. Output by IFP1.
Output Data Block:
None.
Parameters:
SEID Input-integer-no default. Superelement identification number.
SOLAPP Input-character-no default. Design optimization analysis type.
Currently not used.
NSKIP Input/output-integer-no default. The record number in CASECC
corresponding to the first subcase of the current boundary condition.
NLOADS Output-integer-default=0. The number of subcase records contiguous
with respect to the MPC and SPC command in the first subcase of the
current boundary condition.
BCFLAG Output-logical-no default. Set to FALSE at the last boundary condition.
SPC Output-integer-default=0. SPC Case Control command set
identification number specified in the third word of the NSKIP-th
record of CASECC.
MPC Output-integer-default=0. MPC Case Control command set
identification number specified in the second word of the NSKIP-th
record of CASECC.
SUPORT Output-integer-default=0. SUPORT Case Control command set
identification number specified in the 255-th word of the NSKIP-th
record of CASECC.
803