NX Nastran DMAP Programmer's Guide - Kxcad.net

654
Chapter 3
Name
Chapter 2
Name
Description
PVAL0 P-value table generated by the ADAPT module in
previous superelement, adaptivity cycle, or run.
PVAL1 P-value table updated for current superelement or
adaptivity loop. Output by ADAPT.
PVEC Partitioning vector for supported degrees-of-freedom
specified on CYSUP Bulk Data entry. Output by
CYCLIC3.
PVGRID Partitioning vector with ones at rows corresponding to
degrees-of-freedom connected to elements or grids
specified on the following Case Control commands:
DISPLACEMENT, VELOCITY, ACCELERATION,
FORCE, STRESS, STRAIN, SPCFORCE, MPCFORCE,
MPRES, GPFORCE, ESE, EKE, EDE, GPKE. Output by
OUTPRT.
PVLOAD Partitioning vector with ones at rows corresponding to
degrees-of-freedom at which static and dynamic loads
are applied. Output by OUTPRT.
PVMPC Partitioning vector with ones at rows corresponding to
degrees-of-freedom connected to elements or grids
specified on the MPCFORCE Case Control command.
Output by OUTPRT.
PVSPC Partitioning vector with ones at rows corresponding to
degrees-of-freedom connected to elements or grids
specified on the SPCFORCE Case Control command.
Output by OUTPRT.
PVT Table containing parameter values from PARAM Bulk
Data entry images. Output by IFP.
PVTS Table containing parameter values which are resolved
from values in PVT, CASECC, and, optionally, the
NDDL. Output by PVT.
PX Inertial or pseudo-load matrix. Output by DSAP.
PXF Frequency response load matrix in h-set (modal) or d-set.