NX Nastran DMAP Programmer's Guide - Kxcad.net

VIEWP
Generates geometry tables for view mesh in p-element data recovery
VIEWP Generates geometry tables for view mesh in p-element data recovery
Generates geometry tables for the view mesh in p-element data recovery.
Format:
VIEWP GEOM1,GEOM2,EST,CASECC,OINT,EDT,EPT,
PELSET,BGPDT,EQEXIN,CSTM,PVAL0/
ELEMVOL,GEOM1VU,GEOM2VU,VIEWTB/
S,N,VUGNEXT/S,N,VUENEXT/VUGJUMP/VUELJUMP/
VUHEXA/VUPENTA/VUTETRA/VUQUAD4/VUTRIA3/VUBEAM/
S,N,VUEXIST $
Input Data Blocks:
GEOM1 Table of Bulk Data entry images related to geometry.
GEOM2 Table of Bulk Data entry images related to element connectivity and
scalar points.
EST Element summary table.
CASECC Table of Case Control command images.
OINT p-element output control table.
EDT Table of Bulk Data entry images related to element deformation,
aerodynamics, p-element analysis, divergence analysis, and the
iterative solver.
EPT Table of Bulk Data entry images related to element properties.
PELSET p-element set table, contains SETS DEFINITIONS.
BGPDT Basic grid point definition table.
EQEXIN Equivalence table between external and internal grid/scalar
identification numbers.
CSTM Table of coordinate system transformation matrices.
PVAL0 p-value table generated by the ADAPT module in a previous run or
superelement.
Output Data Blocks:
ELEMVOL Element volume table, contains p-element volumes and the p-value
dependencies of each P-element grid, edge, face and body.
GEOM1VU Table of Bulk Data entry images related to geometry with view-grids
added.
150