NX Nastran DMAP Programmer's Guide - Kxcad.net

706
Name Type and Description
'STATICS' Do not ignore boundary condition changes
MODECC Logical. Normal modes analysis subcase flag. Set to TRUE if at least
one ANALYSIS=MODES command was found in CASECC and
CASEMODE is specified in the output list. Output by MDCASE.
MODEPT Logical. Analysis model element property modification flag. Set to
TRUE indicates that the design model is overriding element
properties in the analysis model. Output by DOPR1.
MODETRAK Integer. Mode tracking request flag.
0 Mode tracking was not requested
>0 Mode tracking is requested
MODGEOM2 Logical. Analysis model connectivity modification flag. Set to TRUE
indicates that the design model is overriding connectivity in the
analysis model. Output by DOPR1.
MODGM4 Logical. GEOM4P update flag. Set to TRUE if GEOM4M is updated.
Output by MODGM4.
MODMPT Logical. Analysis model material property modification flag. Set to
TRUE indicates that the design model is overriding material
properties in the analysis model. Output by DOPR1.
MONRPLC Logical. If TRUE then components with duplicate names will be
copied from MON1 into MON.
MPC Integer. MPC Case Control command set identification number
specified in the second word of the NSKIP-th record of CASECC.
MPCF2 Integer. Multipoint constraint set identification number change flag.
Set to 1 if the current subcase contains a different multipoint
constraint set from the previous subcase. Set to -1 otherwise or if
there are no multipoint constraints in the current subcase. Output by
GP4.
MPCFLG Integer. Controls whether the grid point connectivity created by
multipoint constraint Bulk Data entries (MPC, MPCADD, and
MPCAX and the rigid element entries; e.g., RBAR) is considered
during resequencing.
MPCMETH Character. Multipoint constraint processing method. Also indicates
the type of matrix in the second input position: 'RG' for RMG and
'KMM' for KMM.