NX Nastran DMAP Programmer's Guide - Kxcad.net

726
Name Type and Description
PROPOPT Integer. Property optimization flag. Set to 1 if element properties are
defined as design variables. Output by DSABO.
PROPTN Integer. In order to support a pre-Version 68 capability, if
PROPTN=-1 then an EPT data block which is based on the values and
the property to design variable relations will be produced.
PROTYP Integer. Designed property type code. Output by DOPR1.
1 DVPRELi entries exist
2 DVCRELi entries exist
4 DVMRELi entries exist
>0 For combinations add above values
PROUT Integer. Print control for the ELTPRT module.
PRTSWM Logical. UWM 6991 print control flag in NORM module.
PRTUIM Logical. UIM 4570 print control flag in SELA module.
PSEQOPT Character. P-element append flag. Specifies append (default) or
insert option for p-elements in the SEQP module.
PVALNEW Integer. New p-value set identification number. Output by ADAPT.
Q Real. Dynamic pressure. Output by AELOOP and DSARLP.
QUALNAM Character. Name of qualifier to be varied when selecting MAPS from
MAPS* in SEMA, SELA, and SEDR modules. Character. Keyword
which appears on the BEGIN BULK command of the next Bulk Data
section; usually AUXMODEL or SEID. Output by XSORT.
QUALNAMP Character. Name of qualifier to be used in selecting PUG.
QUALVAL Integer. QUALNAM value assigned to the Main Bulk Data section.
R1CNT Integer. Counter for type 1 responses in data block R1TAB. Output by
DOPR3.
R2CNT Integer. Counter for type 2 responses in data block RESP12. Output
by DOPR3.
R3CNT Integer. Counter for type 3 responses in the RESP3 table. Output by
DOPR3.
RBFAIL Logical. Set to TRUE if grounding check does not pass strain energy
threshold used by IOPT=10. Output by VEPCLOT.