NX Nastran DMAP Programmer's Guide - Kxcad.net

Name Type and Description
RCOLLBLi Character. If RCOLLBLi is blank then 'COLUMN' will be printed.
Label with up to 32 characters to be printed right-justified in upper
right corner of each page. RCOLLBLi is then followed by column
number.
REACT Integer. For zero-th and first harmonic, set to -1 if no support
degrees-of-freedom; +1 if support degrees-of-freedom exist. For
harmonics greater than 1 REACT is always -1. Output by CYCLIC3.
REAL Real. Real part of matrix or table element. Output by PARAML.
REALD Real double precision. Real value in the next record.
REALi Real. Real value for PRGNAME.
RECNUM Integer. Record number of table element. Output by PARAML.
REFC Real. Output by PARAML of AERO data block.
REPEAT Integer. Last boundary condition flag. Set to -1 at the last boundary
condition; +1 otherwise. Output by GP4.
RESFLG Integer. Residual vector eigenvalue subheading print flag to be used
by the OFP module.
RESPi Character. Response type.
RESTYP Integer. Optimization results flag.
RGSENS Logical. Rigid element sensitivity flag. Output by DOPR5 or
DSVGP4.
ROWNAM Character. Degree-of-freedom set name for labeling matrix rows in
MATGPR output.
RSEID Integer. Repeated superelement identification number as specified on
the SEBULK Bulk Data entry. Output by SEP2DR and SEDRDR.
RSFLAG Logical. Main Bulk Data superelement presence flag. Set to TRUE if
superelements are defined in the main Bulk Data section. Output by
SEP1X.
727