NX Nastran DMAP Programmer's Guide - Kxcad.net

714
Name Type and Description
On output:
0 Generated
-1 Not generated
NOKBFL Integer. Matrix KBFL existence flag; 0 if KBFL exists and -1 otherwise.
Output by BMG.
NOKVAL Integer. Set to -1 if the value of HINDEX (K) is not in the analysis set
of harmonic IDs. Output by CYCLIC3.
NOL Integer. Dependent set flag. Set to -1 if all degrees-of-freedom belong
to m-set, s-set, o-set, and/or r-set; otherwise, the degrees-of-freedom
in the l-set. Output by GP4.
NOLASM Integer. Load assembly flag. Set to -1 if no load assembly and
reduction is requested for the current superelement based on the
SELR or SEALL Case Control commands. Output by SEP2DR and
SEP3.
NOLOAD Integer. Static load existence flag. Set to -1 if no static loads and SLT is
not created, +1 otherwise. Output by GP3.
NOLOADF Integer. Number of load cases per excitation frequency.
NOLOOP Integer. Looping test flag. Output by CASE.
NOM2 Integer. M2GG or M2PP generation flag. Set to +1 if M2GG or M2PP
is generated; -1 otherwise. Output by MTRXIN.
NOMAT Integer. Matrix generation flag. Set to -1 if no matrix generation is
requested for the current superelement based on the SEMG or SEALL
Case Control commands. Output by SEP2DR and SEP3.
NOMATi Integer. Generation flag. Set to +1 if MAT* is generated; 1 otherwise.
Output by MTRXIN.
NOMGEN Integer. Fluid mass existence flag. Set to the MFLUID set
identification number if MFLUID is specified in CASECC. Output by
MGEN.
NOMGG Integer. Same as NOKGG except for MELM and MDICT. Output by
EMG.
NOMPF2E Integer. Flag to generate O*MPF2E data blocks.