NX Nastran DMAP Programmer's Guide - Kxcad.net

1143
MATGPR
Degree-of-freedom matrix printer
3. Print small terms on diagonal of LOO:
DIAGONAL LOO/LOOD $
MATGPR BGPDT,USET,,LOOD//’H’/’O’//-1.E-2 $
4. Print PHIA, H columns by A rows:
Also good for any single column
MATGPR BGPDT,USET,,PHIA//’H’/’A’ $
5. Print all terms of KGG outside the range of 0 through 10 7 :
MATGPR BGPDT,USET,,KGG//’G’/’G’//1.E7/0. $
6. Print aerodynamic spline matrices:
NP=SEID $
DBVIEW BGPDTF=BGPDTS WHERE (
(PEID=-1 AND MODLTYPE='AEROSTRC') OR
(PEID=NP AND MODLTYPE='STRUCTUR') ) $
DBVIEW USETFF=USET0 WHERE (
(PEID=-1 AND MODLTYPE='AEROSTRC' AND SPC=*
AND MPC=* AND SUPORT=*) OR
(PEID=NP AND MODLTYPE='STRUCTUR' AND SPC=*
AND MPC=* AND SUPORT=*) ) $
MATGPR BGPDTF,USETFF,,GPJK//'K'/'G' $
MATGPR BGPDTF,USETFF,,GDJK//'K'/'G' $
7. Print g-size matrix GCF similarly to displacement output:
MATGPR BGPDT,USET,,GCF//'ofp'/'g' $
MATRIX GCF
POINT ID. TYPE T1 T2 T3 R1 R2 R3
1 G .0 .0 .0 .0 .0 1.862645E-09
3 G -1.303852E-08 -4.656613E-10 .0 .0 .0 1.862645E-09
4 G -1.490116E-08 4.656613E-10 .0 .0 .0 .0
6 G 1.862645E-09 .0 .0 .0 .0 -4.656613E-10
7 G 1.862645E-09 .0 .0 .0 .0 4.656613E-10
9 G -3.725290E-09 .0 .0 .0 .0 .0
10 G -3.725290E-09 .0 .0 .0 .0 .0
8. Same as example 7 except modify header labeling.
MATGPR BGPDTS,USET,,GCFF//'OFP'/'G'//////
'DIRECTIO'/'N'///
////
'G R O U '/'N D C '/'H E C K '/' F O R '/
'C E S ('/' G - S E'/' T )' $
COLUMN 1