NX Nastran DMAP Programmer's Guide - Kxcad.net

3. ETT may be purged if there are no thermal loads
GP3
Processes static and thermal loads
4. If UGH is present in structural analysis run, then GP3 will create a new
temperature set based on UGH with set identification numbers obtained from
TSTRUC command in CASEHEAT. BGPDTH is used to correlate UGH to grid
points. For h-elements ESTH is not required. For p-elements ESTH is appended
to element ETT record for interpolation purposes in element decks. Here are the
DBVIEW statements that are used to define these inputs in SOLs 101-200:
DBVIEW UGH=UG
DBVIEW ESTH=EST
DBVIEW BGPDTH=BGPDTS
(WHERE APRCH='HEAT ' AND WILDCARD) $
(WHERE APRCH='HEAT ' ) $
(WHERE APRCH='HEAT ') $
CASEHEAT can come from the CASE module or DBLOCATE DATABLK=
(CASECCR/CASEHEAT) in the FMS.
105