NX Nastran DMAP Programmer's Guide - Kxcad.net

Word Name Type Description
21 K1 RS Area factor for shear in plane 1
22 K2 RS Area factor for shear in plane 2
Record 10 – PBUSH(1402,14,37)
EPT
Element property table
23 NSM RS Nonstructural mass per unit length
24 RC RS Radial offset of the geometric centroid
25 ZC RS Offset of the geometric centroid
26 DELTAN RS Radial offset of the neutral axis from the
geometric centroid
27 SACL RS Miter spacing at center line.
28 ALPHA RS One-half angle between the adjacent miter
axis (Degrees).
29 FLANGE I For FSI=5, defines the number of flanges
attached.
30 KX RS For FSI=6, the user defined flexibility factor
for the torsional moment.
31 KY RS For FSI=6, the user defined flexibility factor
for the out-of-plane bending moment.
32 KZ RS For FSI=6, the user defined flexbility factor
for the in-plane bending moment.
33 Not used
34 SY RS For FSI=6, the user defined stress
intensification factor for the out-of-plane
bending.
35 SZ RS For FSI=6, the user defined stress
intensification factor for the in-plane
bending.
Word Name Type Description
1 PID I Property identification number
2 K(6) RS Nominal stiffness values
8 B(6) RS Nominal damping coefficient
169