NX Nastran DMAP Programmer's Guide - Kxcad.net

Name Type and Description
NOMR Integer. Mass and damping assembly flag. Set to -1 if no mass and
damping assembly and reduction is requested for the current
superelement based on the SEMR or SEALL Case Control commands.
Output by SEP2DR and SEP3.
NOMSET Integer. Number of degrees-of-freedom in the m-set or multipoint
constraint and rigid element flag. Set to -1 if there are none. Output
by GP4 or PARAML.
NOMSGSTR Integer. MSGSTRES execution flag. Set to -1 if MSGSTRES execution
is not desired.
NONAMEi Integer. NAMEi generation flag. Set to +1 if NAMEi is generated; -1
otherwise. Output by MTRXIN.
NONCUP Integer. Algorithm selection. NONCUP=-1 requests uncoupled
algorithm if SOLTYP='MODAL' and KXX, BXX, and MXX are
diagonal. NONCUP=-2, requests uncoupled algorithm and offdiagonal
terms of KXX, BXX, and MXX will be ignored. GKAM: If
K2DD, B2DD, and M2dd are purged. then the model is considered
uncoupled and NONCUP is set to -1.
NONLFT Integer. Set to 1 if nonlinear forcing function Bulk Data entries are
processed, -1 otherwise. 1 also means PSDL is created. Output by
DPD.
NONLHT Integer. Nonlinear heat transfer flag. Set to -1 if nonlinear heat
transfer elements are detected. Output by EMG.
NOOGS1 Integer. OGS1 creation flag. Set to 0 if OGS1 is created. Output by
GPSTR2.
NOOPT Integer. FRLGEN reexecution flag. Set to -1 for no reexecution.
Output by FRLGEN.
NOOSET Integer. Number of degrees-of-freedom in the o-set or omitted
degree-of-freedom flag. Set to -1 if there are none. Output by GP4 or
PARAML.
NOOUT Integer. Output request flag. Set to -1 if no output requests are
specified for the current superelement. Output by SEDR.
NOP2G Integer. P2G generation flag. Set to +1 if P2G is generated; -1
otherwise. Output by MTRXIN.
NOPG Integer. Upstream load presence flag. Set to -1 if there are no loads
due to upstream superelements. Output by SELA.
715