NX Nastran DMAP Programmer's Guide - Kxcad.net

PLOT Creates a table of plot instructions
PLOT
Creates a table of plot instructions
Creates a table of plot instructions for undeformed and deformed shapes and then
writes the table to Fortran unit 14.
Format:
PLOT PLTPAR,GPSETS,ELSET,CASECC,BGPDT,
Input Data Blocks:
Output Data Blocks:
Parameters:
⎧PUGS ⎫ ⎧PUGD ⎫ ⎧GPECT ⎫ ⎧OES1 ⎫
⎨ ⎬,
⎨ ⎬,
⎨ ⎬,
⎨ ⎬/
⎩USET ⎭ ⎩ ECT ⎭ ⎩ ⎭ ⎩ ⎭
PLOTMSG/
NGP/LUSET/JPLOT/DEFORMED/S,N,PLTNUM $
PLTPAR Table of plot parameters and plot control
GPSETS Table of grid point sets related to the element plot sets
ELSET Table of element plot set connections
CASECC Table of Case Control command images.
BGPDT Basic grid point definition table.
PUGS Matrix of translational displacements in static analysis.
USET Degree-of-freedom set membership table for g-set.
PUGD Matrix of translational displacements in dynamic analysis.
ECT Element connectivity table.
GPECT Grid point element connection table.
OES1 Table of element stresses or strains in SORT1 format.
PLOTMSG Table of user informational messages generated during the plot process.
NGP Input-integer-no default. Number of grid points and scalar points in
the structure.
LUSET Input-integer-no default. The number of degrees-of-freedom in the
g-set. If LUSET=0 then its value will be extracted from the trailer of
BGPDT.
130