NX Nastran DMAP Programmer's Guide - Kxcad.net

Name Type and Description
FOUND Integer. Integer value search flag. Set to -1 if integer value is found by
PARAML. Output by PARAML.
FOURIER Integer. Fourier transform. Set to 1 if TLOADi Bulk Data entries are
referenced by the DLOAD set identification number in CASECC.
Output by FRLG.
FREQDEP Logical. Frequency-dependent element flag. Set to TRUE if
frequency-dependent elements are present or to be processed.
Output by TA1.
FREQINDX Integer. Frequency or time step index. Selects frequency associated
with UA.
FREQTYP Character. Frequency dependent element processing mode:
'ESTF' Compute frequency dependent stiffness
'ESTNF' Compute nominal frequency dependent stiffness
FREQVAL Real. Frequency value for frequency dependent element generation.
Output by FRQDRV.
FREQWA Real. Parameter for electromagnetic analysis.
FRQLOOP Integer. Frequency loop counter. On input, FRQLOOP should be
initialized to 0 before the loop. On output, FRQLOOP is incremented
by one and at the last frequency, FRQLOOP is negated. For example,
if the fifth frequency is the last then FRQLOOP is output as -5.
Output by FRQDRV.
FSDCYC Logical. Fully stressed design cycle flag. Set to TRUE if this is a fully
stressed design cycle.
GAMMAD Complex double preision. This is the scalar multiplier for [C].
GEOMU Integer. Fortran unit number to which the DBC module writes
geometric information.
GETNUMPN Logical. Panel static load computation flag. If TRUE then get number
of panels flag only and do not compute panel static loads.
GMAFLG Integer. Test control flag for changes in the set identification numbers
specified for the SDAMPING, K2PP, M2PP, B2PP, and TFL
commands.
GPF Integer. Parameter for electromagnetic analysis.
697