NX Nastran DMAP Programmer's Guide - Kxcad.net

1287
PARAML
Sets parameters from a data block
PARAML Sets parameters from a data block
Sets parameters from a data block.
Format:
PARAML DB/DBNAME/P1/S,N,P2/S,N,P3/S,N,P4/S,N,P5/S,N,P6/
S,N,SET1/S,N,F1/S,N,SET2/S,N,F2/
S,N,SET3/S,N,F3/S,N,SET4/S,N,F4/
S,N,SET5/S,N,F5/S,N,SET6/S,N,F6/
S,N,SET7/S,N,F7/S,N,SET8/S,N,F8/
S,N,SET9/S,N,F9/S,N,SET10/S,N,F10/
S,N,SET11/S,N,F11/S,N,SET12/S,N,F12 $
Input Data Block:
DB Any matrix or table.
Output Data Block:
DBNAME Any data block. Used only when P1 = ‘NAME’; otherwise DBname
must not be specified.
Parameters:
P1 Input-character-no default. Only the first 4 characters are required. For
example, ‘PRES’ and ‘PRESENCE’ are equivalent.
P2 Input/output-integer-default = 1
P3 Input/output-integer-default = 1
P4 Output-real-default = 0.0
P5 Output-integer-default = 0.0
P6 Output-real-default = 0.0
SETi Input/output-character-default = ‘ ‘.
Fi Output-integer-default = 0
The following describes the various options and their formats. The meaning and
usage of parameters P2 through P6, SETi, and Fi depend on the value of P1. Under all
options P5 will be set to -1, if the input data block does not exist, and no other
parameters will be set.
Option P1 = ‘BULK’