NX Nastran DMAP Programmer's Guide - Kxcad.net

5 Gibbs-King. See Remark 4.
6 Automatic nested dissection. See Remark 4.
SEQP
Resequencing processor
7 Multiple Minimum Degree of Freedom. See Remarks 3 and 4.
8 Semiautomatic selection. See Remark 5.
On output METHOD is set to -1 if new sequence results in a lower
decomposition time estimate. Otherwise it is set to 0.
SETNAME Input-character-default='G'. Degree-of-freedom set name
corresponding to the size of MAT (Format 2 only).
SUPER Input-integer-default=0. Selects coupled or uncoupled sequencing or
special handling of multipoint constraints.
FACTOR Input-integer-default=0. Factor in the computation of the sequenced
identification number (SEQID) on the SEQGP. See Remark 7.
MPCFLG Input-integer-default=0. Controls whether the grid point connectivity
created by multipoint constraint Bulk Data entries (MPC, MPCADD,
and MPCAX and the rigid element entries; e.g., RBAR) is considered
during resequencing.
-1 Do not consider.
0 Consider (default).
>0 Consider only the MPC, MPCADD, and MPCAX entries with a set
identification number equal to this parameter's value as well as the
of the rigid element entries.
START Input-integer-default=0. The number of the grid points at the beginning
of the input sequence. See Remark 8.
MSGLVL Input-integer-default=0. Diagnostic output flag.
0 No
>0 Yes
PEXIST Input-logical-default=FALSE. If set to TRUE then it specifies the
existence of p-elements.
PSEQOPT Input-character-default=' '. Specifies append (default) or insert option
for p-elements. See Remark 9.
140