NX Nastran DMAP Programmer's Guide - Kxcad.net

652
Chapter 3
Name
Chapter 2
Name
Description
PLSETMSG Table of user informational messages generated during
the definition of element plot sets. Output by PLTSET
and SEPLOT.
PLTPAR Table of plot parameters and plot control. Output by
PLTSET and SEPLOT.
PMPF Matrix of contribution of structural panels to fluid mode
participation factors. Output by MODEPF.
PMYG Matrix of equivalent static loads due to enforced
acceleration for the g-set.
PNL Nonlinear load matrix appended from each output time
step. Output by NLTRD, NLTRD2, TRD1, and TRD2.
PNLLST Table of triplets defining panel names and their
associated IPANEL qualifier values
PO Static load matrix partitioned to the o-set. Output by
SSG2.
POI Static load matrix with inertial loads and reduced to the
o-set. Output by SSG4.
POSTCDB Table of commands from the OUTPUT(POST) section of
Case Control. Output by IFP1.
PPF Frequency response load matrix in the p-set. Output by
FRLG.
PPT Transient response load matrix in the p-set for output
time steps. Output by TRLG.
PPVR Partitioning vector for random responses. Output by
DOPRAN.
PRBDOFS Partitioning matrix to partition the "active" URDDI from
the "inactive". Active URRDI are assigned a 1.0 value and
are connected to the SUPORT degrees-of-freedom.
Output by MAKETR.
PROPI Matrix of initial property values. Output by DOPR1.
PROPI* Family of matrices of initial property values. Output by
DOPR1.