NX Nastran DMAP Programmer's Guide - Kxcad.net

There are two table print options controlled by OPT3.
If OPT3=0 (default);
SA 131072
E 2048
SB 1024
SG 512
R 8
O 4
BF 2
M 1
TABPRT TABLE//KEY/OPT1 $
TABPRT
Formatted table printer
SETSTRi Input-character-default=' '. Set name string for the row sort
(OPT1 = 0 or 10). SETSTR1 through SETSTR4 form a single string of
set name(s) and is 32 characters in length. For example,
SETSTR1='M R N SG' and SETSTR2='A Q' specifies the m, r, n, sg, a,
and q sets be printed.
then format statements built into TABPRT are used to print TABLE, as selected by
KEY. These formats are limited to only those values of KEY listed in the table below.
TABLE KEY TABLE KEY TABLE KEY
BGPDT BDPDT ETT ETT GPTT GPTT
CSTM CSTM GPDT GPDT SEMAP SEMAP
EQDYN EQEXIN GPL GPL any FINDIT
EQEXIN EQEXIN GPLD GPLD USET USET
144