NX Nastran DMAP Programmer's Guide - Kxcad.net

Sets
m
sb
sg
o
q
r
c
bf
be*
e
k
sa
j
MATGPR
Degree-of-freedom matrix printer
5. If the value specified for COLNAM is not one of the names shown in Remark 1,
then the columns will be labeled 1,2,3..., etc. without grid and component labels.
6. If the value specified for R is not one of the names shown in Remark 1, then the
terms in each column will be labeled “1 H”, “2 H”, “3 H”, etc. without grid and
component labels. The user must know which sets correspond to the rows and
columns of the matrix to be printed. This is usually apparent from the DMAP
name of the matrix data block.
7. When using Format 1 this module may not be scheduled until after GPSP since
data blocks generated by GPSP are required inputs. (This module may be
scheduled after GP4 if USET0 is specified for input to MATGPR instead of USET.)
When using Format 2 this module may not be scheduled until after DPD since
data blocks generated by DPD are required inputs. When using Format 3,
MATGPR must be scheduled after the APD module.
8. If MATRIX is purged, no printing will be done.
9. The rows and columns of A must correspond to the order of the degrees-offreedom
defined in GPL, USET, SIL, BGPDT, etc.; i.e., internal sequence.
Examples:
1. Print terms of KGG:
MATGPR BGPDT,USET,,KGG//’G’ $
2. Print null columns of KLL:
b
s
l
MATGPR BGPDT,USET,,KLL//’L’/’L’/’NULL’ $
t
a
d
Supersets
*The be set is reserved for a future capability.
f
fe
n
ne
g
js
p
ks
114