NX Nastran DMAP Programmer's Guide - Kxcad.net

938
DRMH1
Converts data recovery tables to matrices and associated directory tables
DRMH1
Converts data recovery tables (e.g., displacements, stresses, strains, forces, SPCforces,
and MPCforces) to matrices and associated directory tables. Similar to DRMS1
module.
Format:
Input Data Blocks:
Output Data Blocks:
Parameters:
Converts data recovery tables to matrices and associated directory
tables
DRMH1 OFP1,OFP2,OFP3,OFP4/
TOFP1,MOFP1,TOFP2,MOFP2,TOFP3,MOFP3,TOFP4,MOFP4/
NCOL/NULLROW/TRL5T1/TRL5T2/TRL5T3/TRL5T4 $
OFPi Output table in SORT1 format usually created by the SDR2 module.
TOFPi Directory table for MOFPi.
MOFPi Matrix form of the i-th output table.
NCOL Input-integer-default=0. Number of columns (i.e.; subcases, modes,
time steps or frequencies) desired in the output matrices. By default,
all data records will be converted into the output matrices. If NCOL is
less than the number of data records in the input table, then the first
NCOL records are converted and the remaining records are ignored.
NULLROW Input-integer-default=1. Flag to insert null rows in the output
matrices for nonlinear quantities. See Remark 1.
0: Insert null rows. Compatible with DRMS1 output format
1: Do not insert null rows. Required for DRMH3 processing
TRL5Ti Output-integer-default=0. Specifies value for the fifth word in
TOFPi's trailer.