NX Nastran DMAP Programmer's Guide - Kxcad.net

Remarks:
1. Data block name table:
DBC
Database converter for model generation and results processing
PROGRAM Character-input-default=’XL’. If PROGRAM =’XL’, then the DBC
database will be suitable for processing in MSC.Patran. If PROGRAM
=’GRASP’, then the DBC database will be suitable for processing in
NX Nastran Access.
OVRWRT Character-input-default=’YES’. DBC data base overwrite flag. If
OVRWRT =’YES’ and the DBC database was created in a prior run,
then data blocks pre-existing on the DBC database will be overwritten
in the current run when the qualifier values are identical.
DESITER Integer-input-defaul =0. Design optimization loop identification
number.
ADPTINDX Integer-input-default=0. When ADPTINDX is not equal to zero, the
data base object attribute will be qualified by the value of this
parameter, which denotes intermediate p-element results exist.
LUSET Integer-input-default=0. NDOF denotes size of the model (number of
degrees of freedom), which will be saved for p-element iterations
indexed by the ADPTINDX values and used to correlate the size of the
model to the p-element iteration index.
Generic
Name
(P1-P20)
Chapter 2
Names
Stored on
Unit
Description
BEPT AEBGPDT --- Aerostructural basic grid point definition
table
BGPDT BGPDT GEOMU Basic grid point definition table
CASECC CASECC POSTU Table of Case Control command images
CONTAB CONTAB POSTU Table of design constraint attributes
CONTROL AECTRL POSTU Table of aerodynamic model's control
definition
CSTM CSTM GEOMU Table of coordinate system
transformation matrices
CVAL CVAL POSTU Matrix of design constraint values
DBCOPT DBCOPT POSTU Design optimization history table for
DESTAB DESTAB POSTU Table of design variable attributes
837