NX Nastran DMAP Programmer's Guide - Kxcad.net

DBEQUIV
Equivalences (or copies) NDDL data blocks and parameters
DBEQUIV Equivalences (or copies) NDDL data blocks and parameters
Equivalences (or copies) NDDL data blocks and parameters based upon a qualifiers in
a CONVERT clause. An optional WHERE and may be specified for a more selective
equivalence.
Format:
DBEQUIV
Describers:
DATABLK =
PARAM =
*
(datablk-list)
*
(param-list)
[ WHERE (where-expr) ] ,
CONVERT (convert-expr) [ OVRWRT RESTART]
$
datablk-list Specifies a list of data blocks separated by commas. The default is *,
which selects all data blocks. The equivalenced data block may be
renamed by specifying a slash after the old name followed by the
new name. For example, if KLL is to be renamed to KLL1, then
DATABLK=(KLL/KLL1) is specified.
param-list Specifies a list of parameters separated by commas. The default is *,
which selected all parameters. The equivalenced parameter may be
renamed by specifying a slash after the old name followed by the
new name. For example, if LUSETS is to be renamed to LUSET,
then PARAM=(LUSETS/LUSET) is specified.
where-expr Logical expression that specifies the desired values of colnames
described in Table 2 under the DBDICT statement. If where-expr is
true then the named items will be equivalenced. For example,
WHERE(VERSION=4 AND SEID2 AND SEID>0) selects all
items under version 4 for all values of SEID greater than 0 except 2.
See “WHERE and CONVERT Clauses” on page 45 for a further
description. The default for VERSION and PROJECT is the current
version and project. See Remark 1 for more information.
861