NX Nastran DMAP Programmer's Guide - Kxcad.net

Name Type and Description
NOA Integer. Constraint and omit set flag. Set to -1 if NOMSET=-1,
NOSSET=-1, and NOOSET=-1; otherwise the number of degrees-offreedom
in the a-set. Output by GP4 and GPSP.
NOABFL Integer. Matrix ABFL existence flag; 0 if ABFL exists and -1
otherwise. Output by BMG.
NOASM Integer. Matrix assembly flag. Set to -1 if no matrix assembly and
reduction is requested for the current superelement based on the
SEKR or SEALL Case Control commands. Output by SEP2DR and
SEP3.
NOB2 Integer. B2GG or B2PP generation flag. Set to +1 if B2GG or B2PP is
generated; -1 otherwise. Output by MTRXIN.
NOBGG Integer. Same as NOKGG except for BELM and BDICT. Output by
EMG.
NOBKGG Integer. Slideline contact stiffness generation flag. Set to 1 to generate
slideline contact stiffness.
NOBSET0 Integer. Number of null columns in PHZ in front of non-null
columns. Output by DYNREDU.
NOCEAD Integer. Complex eigenvalue analysis flag. Set to 1 if complex
eigenvalue analysis needs to be performed, otherwise, set to -1.
Output by FA1.
NOCHAR Integer. Number of character value inputs.
NOCMPX Integer. Number of complex value inputs.
NOCOMP Integer. Composite stress/strain flag.
-5 Forces of composites in STRAIN=sid
-2 Forces of composites in STRESS=sid
-1 Stresses for all elements (same as 0 except in DMAP)
0 Stresses for all elements
1 Stresses for non-composites only
2 Strain/curvature and forces of composites in STRESS=sid
3 Strains for all elements and MPCForces
4 Strains for non-composites only
5 Strain/curvature of composites in STRAIN=sid
711