NX Nastran DMAP Programmer's Guide - Kxcad.net

1505
VECPLOT
Transforms, searches, and computes resultants of matrices
IOPT Contents of XOUT Printed Output
where [XOUT4] is the rigid body matrix
generated under PLOTFORM = 4, and
[DRR] is the partition of [XOUT4]
corresponding to the six r-set degrees of
freedom defined in the USET table. There
must be six and only six r-set degrees of
freedom which completely describe the six
rigid body modes. The r-set degrees of
freedom may be defined on more than one
grid point. If the r-set degrees of freedom
belong to a single grid point, then the
result is the same as IOPT=4, except that
the unit motions of the grid point listed on
PARAM, GRDPNT are in its global, rather
than basic coordinate system.
7 Grid point weight generator summary
table suitable for printing by the OFP
module. Same as GPWG module.
2. If displacement coordinate systems exist, or COORID = 0, then CSTM may not be
purged and SCSTM may not be purged if partitioned superelements are present.
3. CASECC and LAMA may be purged.
4. BGPDT and XOUT may not be purged.
5. XG may be purged if IOPT=3, 4, or 6.
6. MEDGE may be purged if p-elements are not present.
None
8 Same as IOPT=1. Same as IOPT=1 except
output includes
contributions from each
direction.
9 Same as IOPT=7. None
10 Same as IOPT=7. User Information
Message 7570, which
shows grounding check
strain energies and
pass/fail report.