NX Nastran DMAP Programmer's Guide - Kxcad.net

1259
NXNADAMS
Creates an ADAMS MNF for a superelement.
NXNADAMS Creates an ADAMS MNF for a superelement.
Creates an ADAMS Modal Neutral File (MNF) for a superelement. The output is
based on the definitions in the ADAMSMNF case control command and the
DTI,UNITS bulk data entry.
Format:
NXNADAMS UNITS,CASES,BGPDTS,GEOM2,USET,LAMA,PHIG,
MGGDIAG,PCDB,OGPWG,OGSR1,OGSTRR1,CSTMS//
SEID/FLXONL/FLXERR/WTMASS/GRDPNT $
Input Data Blocks:
UNITS UNITS data block from the DTI,UNITS bulk data entry.
CASES Case Control table associated with superelement.
BGPDTS Basic Grid Point Definition Table associated with superelement.
GEOM2 Table of Bulk Data entries related to element connectivity.
USET Table of degree-of-freedom sets.
LAMA Eigenvalue summary table for superelement.
PHIG Matrix of eigenvectors (g-set size) corresponding to LAMA
MGGDIAG Column vector of diagonal values from superelement mass matrix
(g-set size).
PCDB Plot Control Data Block from OUTPUT(PLOT) case control.
OGPWG Output table of Grid Point Weight Generator of superelement.
OGSR1 Output table of grid point stresses of superelement.
OGSTRR1 Output table of grid point strains of superelement.
CSTMS Coordinate System Transformation Matrices for superelement.
Parameters:
SEID Input-integer-default=0. Superelement ID number (0 for residual-only
analysis).
FLXONL Output-integer-no default. Value of FLEXONLY keyword from
ADAMSMNF case control command. Options are:
0 Continue with solution of residual structure
1 Do not perform solution of residual structure